Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Keyless Transmitter
INSPECTION
1. KEYLESS TRANSMITTER BATTERY
1. Check the keyless transmitter battery voltage.
PREPARATION TOOL:
Circuit tester
NOTE:
Complete the measurement within 5 seconds because the battery discharges during measurement.
Battery terminal | Inspection Conditions | Standard |
(+) — (−) | Connect resistor (A) 47 ? | 2.5 — 3.0 V |
2. Replace the battery if the inspection result is not within the standard. (Use CR1620 or equivalent.)
Replacement
SECURITY AND LOCKS > Keyless TransmitterREPLACEMENT1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITORNOTE:• A maximum of four keyless transmitters can be registered for each in ...
Other materials:
Note
WHEEL AND TIRE SYSTEM > Temporary TireNOTE“T-type” or “Temporary” tire for temporary use is equipped as a temporary tire.CAUTION:• The “T-type” or “Temporary” tire is only for temporary use. Replace with a conventional tire as soon as possible ...
Preparation tool
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subar ...
Removal
EXHAUST(H4DO) > Center Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Turn the ignition switch to OFF.2. Lift up the vehicle.3. Remove the bolts, springs, and nuts securing the rear exhaust pipe to the center exhaust ...
