Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Security and locks / Keyless buzzer / Inspection

SECURITY AND LOCKS > Keyless Buzzer

INSPECTION

Using the Subaru Select Monitor, perform forced operation of the keyless buzzer. User Customizing > OPERATION">

If the buzzer does not sound, replace the keyless buzzer.

Removal

SECURITY AND LOCKS > Keyless BuzzerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the clips and screws, and turn over the front side of the mud ...

Other materials:

Disassembly
MECHANICAL(H4DO) > Cylinder HeadDISASSEMBLY1. Remove the chain cover securing bolt from the cylinder head LH.2. Remove the stud bolts from the cylinder head.3. Remove the valve collet, valve, valve spring retainer, valve spring and valve spring seat from the cylinder head RH.CAUTION:During work, ...

Electrical specification
SECURITY AND LOCKS > Keyless Entry SystemELECTRICAL SPECIFICATION1. KEYLESS ENTRY CONTROL MODULE• Model without tire pressure monitoring systemTerminal No.ItemMeasuring conditionStandard3 (U-ART com.) — Cannot be measured — 4 (+B) ←> Chassis groundVoltageAlways10 — 14 V7 (GND) ...

Preparation tool
DRIVE SHAFT SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONPART NO.DESCRIPTIONREMARKS20099PA010INSTALLER & REMOVER• Used for replacing the rear bushing of rear axle housing.• Used together with BUSHING REMOVER (20099FG000).20099FG000BUSHING REMOVER• U ...