Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Front Hood Lock Assembly
INSPECTION
Check if the lock assembly operates normally.
If lever deformation, abnormal wear, or unsmooth lock operation is observed, replace the lock assembly - front hood.
Removal
SECURITY AND LOCKS > Front Hood Lock AssemblyREMOVAL1. Open the front hood.2. Remove the clip, and remove the bracket - grille.NOTE:To prevent damage to the bracket - grille, make sure to remove al ...
Installation
SECURITY AND LOCKS > Front Hood Lock AssemblyINSTALLATION1. Before installation, check the following items.• Is the cable deformed?• Grease is applied sufficiently to cable joints.If gr ...
Other materials:
Engine oil pressure Inspection
MECHANICAL(H4DO) > Engine Oil PressureINSPECTION1. Disconnect the ground cable from battery. NOTE">2. Remove the oil pressure switch. Oil Pressure Switch > REMOVAL">3. Install the oil pressure gauge to the chain cover.4. Connect the battery ground terminal. NOTE">5. ...
Removal
ENTERTAINMENT > Front Accessory Power Supply SocketREMOVALCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.1. Disconnect the ground cable from battery and wait for at least 60 seconds be ...
Auto light sensor sensitivity setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Auto Light Sensor" item. Then
push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Selec ...
