Subaru Crosstrek Service Manual: Inspection
SEAT BELT SYSTEM > Front Seat Belt
INSPECTION
1. VISUAL INSPECTION
Check for the following, and replace with new parts if necessary.
• Pretensioner is cracked or deformed.
• Adjuster assembly - seat belt is cracked or deformed.
• Seat belt is slackened, bent or worn.
• Seat belt is abnormally wound or extended.
• Seat belt inner - front is deformed or damaged.
• Seat belt buckle cannot be engaged properly.
2. ELR LOCK MECHANISM INSPECTION
1. Hold the retractor upright (as installed in the vehicle) and check the ELR lock mechanism.
2. Tilt the retractor from the upright posture and check the following points.
• It does not lock if the inclination angle is 15° or less.
• It remains locked if the inclination angle is 27° or more.
3. If the ELR lock mechanism does not operate properly, replace the seat belt outer - front with a new part.
3. SEAT BELT SWITCH INSPECTION
Preparation tool:
Circuit tester
• Driver’s seat
Check the resistance between the terminals when the seat belt inner - front is in each of the following operation conditions.
Terminal No. | Inspection conditions | Standard | Circuit |
2 — 1 | Tongue plate inserted | 1 M? or more |
2 — 1
Tongue plate detached
1 ? or less
Replace the seat belt inner - front if the inspection result is not within the standard.
• Passenger’s seat
Check the current between the terminals when the seat belt inner - front is in each of the following operation conditions.
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Tongue plate inserted | 12 — 18 mA |
1 — 2
Tongue plate detached
4 — 7 mA
Replace the seat belt inner - front if the inspection result is not within the standard.
Front seat belt
...
Removal
SEAT BELT SYSTEM > Front Seat BeltREMOVAL1. SEAT BELT OUTER - FRONTCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” ...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Cowl PanelREMOVAL1. Open the front hood.2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">3. Remove the cowl panel - side.(1) Remove the clips.(2) Release the claws, and then remove the cowl panel - side.CAUTION:Pulling with excessive f ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSPECTION1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resistance between the back-up light switch terminals.Gear shift positionTerminal No.Specified resistanc ...
Dtc p1496 coil 3 egr "a" control circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1496 COIL 3 EGR "A" CONTROL CIRCUIT LOWNOTE:For the diagnostic procedure, refer to DTC P1498. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1498 COIL 4 EGR "A" CONTROL ...
