Subaru Crosstrek Service Manual: Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering Wheel
INSPECTION
1. PADDLE SHIFT SWITCH
Check the resistance of paddle switch.
| STEP | CHECK | YES | NO |
1.SHIFT-UP SWITCH CONTINUITY CHECK.
1) Operate the + side of paddle shift assembly and hold it.
2) Measure the resistance between terminals of the paddle shift assembly connector.
Terminals
No. 4 — No. 3:
Is the resistance less than 10 ??
Steering Wheel > INSPECTION">Go to Step 2.
Replace the paddle shift assembly.
2.SHIFT-DOWN SWITCH CONTINUITY CHECK.
1) Operate the − side of paddle shift assembly and hold it.
2) Measure the resistance between terminals of the paddle shift assembly connector.
Terminals
No. 1 — No. 4:
Is the resistance less than 10 ??
Steering Wheel > INSPECTION">Go to Step 3.
Replace the paddle shift assembly.
3.CHECK SHIFT SWITCH INSULATION.
1) Do not operate the paddle shift assembly.
2) Measure the resistance between terminals of the paddle shift assembly connector.
Terminals
No. 4 — No. 3:
No. 1 — No. 4:
Is the resistance 1 M? or more?
Paddle shift assembly is normal.
Replace the paddle shift assembly.
Replace the paddle switch if the inspection result is not within the standard value.
2. SATELLITE SWITCH ASSEMBLY
• Audio (navigation) switch: Switches and Harness > INSPECTION">
• EyeSight steering switch Switches and Harness > INSPECTION">
• Cruise control command switch: Cruise Control Command Switch > INSPECTION">
3. MID SWITCH
Refer to “Steering Switch” of “INSTRUMENTATION/DRIVER INFO” section. Steering Switch > INSPECTION">
Disassembly
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelDISASSEMBLY1. CROSSTREK MODEL1. Remove the screw, disconnect the connector and remove the paddle shift switch. (Model with paddle shift)2. Rel ...
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” ...
Other materials:
Dtc b1571 reference code incompatibility (immobilizer cm to ecm)
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1571 REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CM TO ECM)DTC DETECTING CONDITION:Reference code incompatibility between body integrated unit and ECMCAUTION:When the body integrated unit is replaced, registra ...
Washing
CAUTION
When washing the vehicle, the
brakes may get wet. As a result,
the brake stopping distance will
be longer. To dry the brakes,
drive the vehicle at a safe speed
while lightly depressing the
brake pedal to heat up the
brakes.
Do not wash the engine compartment
and area ad ...
Installation
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorINSTALLATIONCAUTION:• Be careful not to damage the sensor.• Do not apply excessive force to the sensor harness.Install each part in the reverse order of removal.NOTE:• Check the identification (mark) on the harness to ...
