POWER ASSISTED SYSTEM (POWER STEERING) > Steering Column
INSPECTION
1. UNIT INSPECTION
Check the following items, and if there is anything out of standard value, it is considered to be damaged. If so, replace it with a new part.
• Measure the whole length of the column assembly - steering.
Standard: Overall length L
Tilt and telescopic column (measure while minimized)
819.7+1.5 −1.5 mm (32.27+0.059 −0.059 in)
• Check the steering wheel deflection in axial and vertical directions.
Specification:
Axial deflection A (deflection of steering wheel)
Less than 6 mm (0.24 in)
Vertical deflection L (runout of steering wheel)
Less than 17 mm (0.68 in)
2. INSPECTION OF AIRBAG SYSTEM
Refer to “Airbag System” for airbag inspection procedure. Driver’s Airbag Module > INSTALLATION">
Fuel pressure Inspection
MECHANICAL(H4DO) > Fuel PressureINSPECTION1. Release the fuel pressure. Fuel > PROCEDURE">2. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel tank.3. Disconnect the fuel delivery tube from the fuel delive ...
Windshield washer fluid
Windshield washer fluid warning light (type A)
Windshield washer fluid warning light (type B)
When there is only a small amount of
washer fluid remaining, the windshield
washer fluid warning light will illuminate.
When this occurs, refill the washer fluid. ...
Installation
FRONT SUSPENSION > Front Ball JointINSTALLATION1. Install the ball joint assembly to the housing assembly - front axle.CAUTION:• Do not apply grease to the tapered portion of ball stud.• Before tightening, make sure the bottom surface of the housing assembly - front axle and the stepp ...