MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Gear Oil
INSPECTION
1. Park the vehicle on a level surface.
2. Turn the ignition switch to OFF, and wait until the engine cools.
3. Remove the oil level gauge and wipe it clean.
4. Reinsert the oil level gauge all the way. Be sure that the oil level gauge is correctly inserted in the proper direction.
5. Pull out the oil level gauge again, and check the oil level. If it is below the lower level, check for oil leakage and add oil through the oil level gauge hole to bring the level up to the upper level.
CAUTION:
The length of the oil level gauge varies depending on models and destinations. Make sure to use the appropriate oil level gauge.
(A) | Oil level gauge |
(B) | Upper level |
(C) | Lower level |
(1) | Gray |
(2) | 195.9 mm (7.71 in) |
Keyless buzzer volume setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the button.
3. Select a volume level by operating the
" " or "
" switch, and confirm the set ...
Wheel alignment Inspection
REAR SUSPENSION > Wheel AlignmentINSPECTIONNOTE:Measure and adjust the front and rear wheel alignment at a time. Refer to “Wheel Alignment” in “FRONT SUSPENSION” section for measurement or adjustment of wheel alignment.• Inspection: Wheel Alignment > INSPECTION&q ...
Removal
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">3. Remove the trim panel - front door. Door T ...