MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive Gear
INSPECTION
1. Ball bearing
Replace the bearings in the following cases.
• In case of broken or rusty bearings
• In case of worn or damaged bearings
• When the bearings fail to turn smoothly or emit noise in rotation after transmission gear oil lubrication.
2. Transfer drive gear
If the drive gear tooth surface and shaft are excessively broken or damaged, replace the drive gear.
3. Measure the clearance between snap ring and inner race of ball bearing with a thickness gauge.
Clearance:
0.01 — 0.15 mm (0.0004 — 0.0059 in)
If the measurement is not within specification, select a suitable snap ring and replace it.
Snap ring (outer-30) | |
Part No. | Thickness mm (in) |
805030041 | 1.53 (0.0602) |
805030042 | 1.65 (0.0650) |
805030043 | 1.77 (0.0697) |
Dtc u0073 control module communication bus off
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFNOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as N ...
Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...
Removal
WIPER AND WASHER SYSTEMS > Combination Switch (Wiper)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Release the clips, and remove the cover assembly - steering UPR.(2) Remove the screws by turning the steering wheel to right and left.( ...