MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and Harness
INSPECTION
1. BACK-UP LIGHT SWITCH
1. Turn the ignition switch to OFF.
2. Disconnect the back light switch connector.
3. Measure the resistance between the back-up light switch terminals.
Gear shift position | Terminal No. | Specified resistance |
Reverse position | 1 and 2 | Less than 1 ? |
Other positions | 1 M? or more |
4. Replace faulty parts.
2. NEUTRAL POSITION SWITCH
1. Turn the ignition switch to OFF.
2. Disconnect the connector of neutral position switch.
3. Measure the resistance between neutral position switch terminals.
Gear shift position | Terminal No. | Specified resistance |
Neutral position | 1 and 2 | Less than 1 ? |
Other positions | 1 M? or more |
4. Replace faulty parts.
Procedure
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Preparation for OverhaulPROCEDURE1. Clean the transmission exterior.2. Remove the torque converter assembly. Torque Converter Assembly">3. Attach the ST on the transmission.ST 18632AA000STAND ASSY4. Remove the transmission case cover on the ...
Dtc b2300 rear radar circuit low
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2300 REAR RADAR CIRCUIT LOWDTC detecting condition:• Short circuit to ground in the harness between radar sensor and outer mirror assembly• Ground short circuit of ...
Dtc p0970 pressure control solenoid "c" control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0970 PRESSURE CONTROL SOLENOID "C" CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Drivability getting worse.CAUTION:Use the check bo ...