MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler Gear
INSPECTION
1. Move the reverse shifter rod toward the reverse side. Check the clearance between the reverse idler gear and the transmission case wall surface.
If the value is out of specification, select the appropriate reverse shifter lever and adjust. Reverse Idler Gear > ADJUSTMENT">
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
2. After installing a suitable reverse shifter lever, shift into neutral. Check the clearance between the reverse idler gear and the transmission case wall surfaces.
If the value is out of specification, select the appropriate adjusting washer and adjust. Reverse Idler Gear > ADJUSTMENT">
Clearance:
0 — 0.5 mm (0 — 0.020 in)
3. Check the reverse idler gear and shaft for damage. Replace if it is damaged.
Towing hooks and tie-down hooks/holes
The towing hooks should be used only in
an emergency (e.g., to free a stuck vehicle
from mud, sand or snow).
CAUTION
Use only the specified towing
hooks and tie-down hooks/holes.
Never use suspension parts or
other parts of the body for towing
or tie-down purposes.
To prevent defo ...
Glove box
Lock
Unlock
To open the glove box, pull the handle. To
close it, push the lid firmly upward.
To lock the glove box, insert the key and
turn it clockwise. To unlock the glove box,
insert the key and turn it counterclockwise.
For models with "keyless access with
push-button start s ...
New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do not race the engine. And do not
allow engine speed to exceed 4,000 rpm
except in an emergency
...