MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve
INSPECTION
• Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.
• Turn the cam by hand to check for smooth rotation.
• Move the cam and shaft all the way toward the plate, and make sure it releases.
If the cam does not return properly, replace the reverse check spring. If the shaft does not return, check for scratches on the inner surface of sleeve. If the sleeve is in good order, replace the spring.
(A) | Snap ring |
(B) | Reverse check plate |
(C) | Reverse check spring |
(D) | Reverse check cam |
• Select a suitable reverse accent shaft and reverse check plate. Reverse Check Sleeve > ADJUSTMENT">
Parking brake
To set the parking brake, depress the
brake pedal firmly and hold it down until
the parking brake lever is fully pulled up.
To release the parking brake, pull the lever
up slightly, press the release button, then
lower the lever while keeping the button
pressed.
When the parking brake i ...
Most common causes of corrosion
The most common causes of corrosion
are:
The accumulation of moisture retaining
dirt and debris in body panel sections,
cavities, and other areas.
Damage to paint and other protective
coatings caused by gravel and stone
chips or minor accidents.
Corrosion is accelerated on the vehic ...
Installation
EXHAUST(H4DO) > Rear Exhaust PipeINSTALLATION1. Apply a coat of spray type lubricant to the mating area of cushion rubber.2. Install the rear exhaust pipe to cushion rubber.NOTE:After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.3. Install t ...