LUBRICATION(H4DO) > Oil Pressure System
INSPECTION
STEP | CHECK | YES | NO |
1.CHECK ENGINE OIL AMOUNT.
Is the engine oil amount normal? Engine Oil > INSPECTION">
Oil Pressure System > INSPECTION">Go to Step 2.
Adjust the engine oil amount. Engine Oil > INSPECTION">
After the operation is complete, go to the next step. Oil Pressure System > INSPECTION">Go to Step 2.
2.CHECK DTC.
Is DTC for engine displayed? Read Diagnostic Trouble Code (DTC)">
Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">
Oil Pressure System > INSPECTION">Go to Step 3.
3.CHECK POWER SUPPLY TO OIL PRESSURE SWITCH.
1) Turn the ignition switch to OFF.
2) Disconnect the terminal from oil pressure switch.
3) Turn the ignition switch to ON (engine OFF).
4) Measure the voltage of harness between oil pressure switch harness terminal and chassis ground.
Terminals
(E11) No. 1 (+) — Chassis ground (−):
Is the voltage 10 V or more?
Replace the oil pressure switch. Oil Pressure Switch">
Oil Pressure System > INSPECTION">Go to Step 4.
4.CHECK COMBINATION METER.
Perform the self-diagnosis of combination meter to check if there are any faults in the combination meter. Combination Meter System > OPERATION">
Is combination meter OK?
Repair the harness and connector.
NOTE:
In this case, repair the following item:
• Open circuit or short circuit of harness between combination meter and oil pressure switch
• Poor contact of combination meter connector
• Poor contact of coupling connector
Repair or replace the combination meter. Combination Meter System > INSPECTION">
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control DeviceINSTALLATION1. Install the parking support.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Install the extension case. Extension Case > INSTALLATION">3. Install the manual valve.4. Install the parking rod ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the air breather hose. Air Breather Hose > REMOVAL">3. Remove the control valve body. Control Val ...
Air cleaner element
WARNING
Do not operate the engine with the
air cleaner element removed. The air
cleaner element not only filters
intake air but also stops flames if
the engine backfires. If the air
cleaner element is not installed
when the engine backfires, you
could be burned.
CAUTION
When replacing the ...