Subaru Crosstrek Service Manual: Inspection

CAUTION:

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.

1. Park the vehicle on a level surface.

2. Turn the ignition switch to OFF.

3. Remove the oil level gauge and wipe away the oil.

4. Reinsert the oil level gauge all the way. Be sure that the oil level gauge is correctly inserted and properly orientated.

5. Pull out the oil level gauge again, and check both sides of the oil level gauge. Use a lower side to determine the engine oil level. If the engine oil level is below “L” line, check for oil leakage from engine and add oil to bring the level up to “F” line.

6. Start the engine to circulate the oil in engine.

7. After turning off the engine (ignition OFF), wait a few minutes for the oil to return to the oil pan before checking the level.

NOTE:

• To prevent overfilling of engine oil, do not add oil above “F” line when the engine is cold.

• As the oil level gauge is used for daily maintenance, “F” line and “L” line is set assuming that the engine is cold.

Engine oil

Replacement

Other materials:

Dtc b28ac stereo camera asic
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28AC STEREO CAMERA ASICDetected when communication error occurs due to malfunction of ASIC.DTC DETECTING CONDITION:Communication error occurs due to malfunction of ASIC.TROUBLE SYMPTOM:All functions of EyeSight s ...

Operation
EyeSight (DIAGNOSTICS) > EyeSight Temporary Code(s) DisplayOPERATIONIf the EyeSight pause code is detected from the stereo camera, all the functions of the EyeSight excluding the conventional cruise control stop temporarily and cannot be used. When the failure is resolved, the function starts ope ...

Registering a Bluetooth phone for the first time
To use the hands-free system, it is necessary to register a Bluetooth phone with the system. For details about registering a Bluetooth device: Refer to "Registering a Bluetooth Audio device for the first time" 1. Turn the Bluetooth connection setting of your cell phone on. This function ...