LIGHTING SYSTEM > Spot Map Light
INSPECTION
1. SPOT MAP LIGHT BULB
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
2. SPOT MAP LIGHT SWITCH
1. Check the resistance between switch terminals.
Preparation tool:
Circuit tester
• Models without EyeSight
– Model without sunroof
Terminal No. | Inspection conditions | Standard | Connection diagram |
1 — 2 | Switch OFF | 1 M? or more |
Switch ON
Approx. 18 ?
– Model with sunroof
Terminal No. | Inspection conditions | Standard | Connection diagram |
1 — 4 | Switch OFF | 1 M? or more |
Switch ON
Approx. 18 ?
• Models with EyeSight
Terminal No. | Inspection conditions | Standard | Connection diagram |
11 — 12 | Switch OFF | 1 M? or more |
Switch ON
Approx. 18 ?
2. Replace the light assembly - map if the inspection result is not within the standard value.
Removal
SECURITY AND LOCKS > Immobilizer AntennaREMOVAL1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to right and left.(2) Release the claw, and re ...
Installation
MECHANICAL(H4DO) > Engine AssemblyINSTALLATION1. Install the engine mounting onto the engine.Tightening torque:35 N·m (3.6 kgf-m, 25.8 ft-lb)2. Apply a small amount of grease to splines of main shaft. (MT model)Grease:NICHIMOLY N-130 or equivalent3. Position the engine in engine compartmen ...
Dtc p2763 torque converter clutch pressure control solenoid control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2763 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• No lock-up occurs.• Engin ...