LIGHTING SYSTEM > Room Light
INSPECTION
1. ROOM LIGHT BULB
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
2. ROOM LIGHT SWITCH
1. Check the resistance between switch terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connection diagram |
1 — 3 | Switch OFF | 1 M? or more |
Switch ON
Less than 1 ?
2 — 3
Switch door
Less than 1 ?
2. Apply battery voltage to check the lighting condition of the light.
Terminal No. | Inspection conditions | Specification | Connection diagram |
3 (+) — 1, 2 (−) | Switch OFF | Light OFF |
Switch ON
Light ON
Switch door
Light ON
3. Replace the light assembly - room if the inspection result is not within the standard value.
Basic diagnostic procedure Procedure
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition of how trouble occurs.Did you interview the customer? Basic Diagnostic Procedure > PROC ...
Removal
SECURITY AND LOCKS > Keyless BuzzerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the clips and screws, and turn over the front side of the mud guard - front RH.4. Remove the keyless buzzer.(1) Disconnect the connector.(2) Remove the clip and d ...
Basic diagnostic procedure Procedure
EyeSight (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Start the diagnosis after the engine has started. (Cruise control main switch does not turn on even if it is pressed before the engine starts.)• When performing diagnosis, observe the legal speed limit on the road.& ...