LIGHTING SYSTEM > Rear Combination Light Assembly
INSPECTION
1. Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. | Inspection conditions | Specification |
6 (+) — 3 (−) | Apply battery voltage. | Stop light on |
2 (+) — 3 (−) | Tail (small) / side marker light on | |
4 (+) — 3 (−) | Turn signal light on | |
1 (+) — 3 (−) | Back-up light on |
2. Replace the harness and bulb if it is found defective.
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control ValveINSTALLATIONInstall in the reverse order of removal.NOTE:Use new O-rings and gaskets.Tightening torque:22 N·m (2.2 kgf-m, 16.2 ft-lb)Tightening torque:3 N·m (0.3 kgf-m, 2.2 ft-lb) ...
Removal
AIRBAG SYSTEM > Side Airbag SensorREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
Tire Identification Number (TIN)
Tire Identification Number (TIN) is
marked on the intended outboard
sidewall. The TIN is composed of
four groups. Here is a brief review
of the TIN with a breakdown of its
individual elements.
(1) Manufacturer's Identification
Mark
(2) Tire Size
(3) Tire Type Code
(4) Date of Manufacture
...