Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Luggage Room Light
INSPECTION
1. LUGGAGE ROOM LIGHT BULB
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
2. LUGGAGE ROOM LIGHT SWITCH
1. Check the resistance between switch terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Specification | Connection diagram |
1 — 2 | Switch OFF | 1 M? or more |
Switch ON
Less than 1 ?
2. Replace the light assembly - luggage room if the inspection result is not within the standard value.
Removal
LIGHTING SYSTEM > Luggage Room LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - luggage room.CAUTION:When using a flat tip screwdriver, apply p ...
Other materials:
Check cruise indicator light and cruise set indicator light
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostics with PhenomenonCHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHTTROUBLE SYMPTOM:Cruise control can be set, but the CRUISE indicator and SET indicator do not illuminate.STEPCHECKYESNO1.CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR ...
Catalytic converter
The catalytic converter is installed in the
exhaust system. It serves as a catalyst to
reduce HC, CO and NOx in exhaust
gases, thus providing cleaner exhaust.
To avoid damage to the catalytic converter:
Use only unleaded fuel. Even a small
amount of leaded fuel will damage the
cata ...
Dtc p0125 insufficient coolant temperature for closed loop fuel control
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0125 INSUFFICIENT COOLANT TEMPERATURE FOR CLOSED LOOP FUEL CONTROLDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Engine does not return to idle.CAUTION:A ...
