LIGHTING SYSTEM > Light Control Sensor
INSPECTION
1. Turn the ignition switch to ON.
2. Set the lighting switch to AUTO position.
3. Check the voltage between the sensor terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connection diagram |
2 (+) — 1 (−) | Measure the voltage when the area around the sensor - automatic light, which was dark, becomes bright. | Dark condition: Approx. 0.6 V or less |
Bright condition: Approx. 3.0 V or more
4. Replace the sensor - automatic light if the inspection result is not within the standard value.
Using the cover
To extend the cover, pull the end of the
cover out of the housing, then insert its
hooks into the catches as shown. To
rewind it, unhook it from the catches and
it will rewind automatically. You should
hold on to the cover and guide it back into
the cover housing while it is rewinding.
WA ...
Replacement
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension Case Oil SealREPLACEMENTCAUTION:Immediately after the vehicle has been running or after idling for a long time, the CVTF will be hot. Be careful not to burn yourself.1. Lift up the vehicle.2. Remove the center exhaust pipe. Center Exhaust Pip ...
Electrical component location Location
LAN SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)VDC CM(7)Combination meter(12)Data link connector(2)Power steering CM(8)A/C control panel(13)Transmission CM(3)Stereo camera(9)MFD(14)Airbag CM(4)Radar sensor LH(10)Data communication module (DCM)(15)Engine CM(5)Auto headlight bea ...