Subaru Crosstrek Service Manual: Inspection

1.CHECK THE IGNITION SWITCH ILLUMINATION.

Make sure the ignition switch illumination illuminates when driver’s side door is open.

Does the ignition switch illumination illuminate?

Ignition switch illumination is normal.

Ignition Switch Illumination > INSPECTION">Go to Step 2.

2.CHECK THE IGNITION SWITCH ILLUMINATION.

Make sure the ignition switch illumination blinks when the ignition switch is turned to ON.

Does the ignition switch illumination blink?

Check the function setting of body integrated unit. Basic Diagnostic Procedure">

Check the ignition switch illumination circuit. Keyless Entry System > INSPECTION">

Ignition switch illumination

Removal

Other materials:

Specification
LIGHTING SYSTEM > General DescriptionSPECIFICATIONNo.DescriptionCapacity and wattageType(1)HeadlightLow beam (halogen type)12 V — 55 WH11Low beam (HID type)12 V — 35 WD2RHigh beam12 V — 60 WHB3Front turn signal light12 V — 21 WWY21WParking light12 V — 5 WW5WSide marker light12 V — 5 W ...

Removal
LIGHTING SYSTEM > Ignition Switch IlluminationREMOVALNOTE:The ignition switch illumination is integrated into the immobilizer antenna assembly.1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to r ...

Dtc b1623 side airbag sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1623 SIDE AIRBAG SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Side airbag sensor (RH) an ...