LIGHTING SYSTEM > High-mounted Stop Light
INSPECTION
1. Install the light to test if it illuminates normally.
2. If it fails to illuminate normally, replace the light assembly - high-mounted with a new part.
NOTE:
Since LED (Light Emitting Diode) is used for the light, replace the light assembly - high-mounted if the LED burns out.
Shift lock release
If the select lever cannot be operated, turn
the ignition switch back to the "ON"
position then move the select lever to the
"P" position with the select lever button
pressed and brake pedal depressed.
If the select lever does not move after
performing the above procedure, perform
the follo ...
Daytime running light system
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the " " position when it
is dark outside.
The high beam headlights will automatically
illuminate at reduced brightness
when the ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the clips, and remove the under cover assembly - passenger.3. Remove the blower - motor.(1) Disconnect the connector.(2) Remove the screws and detach the blower - m ...