LIGHTING SYSTEM > Hazard Switch
INSPECTION
1. Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard |
2 — 3 | Switch OFF | 1 M? or more |
Switch ON | Less than 1 ? |
2. Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. | Inspection conditions | Specification |
4 (+) — 1 (−) | Apply battery voltage. | Light ON |
3. Replace the switch - hazard if the inspection result is not within the standard value.
Folding down the rear seatback
WARNING
When you fold down the seatback,
check that there are no
passengers or objects on the
rear seat. Not doing so creates
a risk of injury or property damage
if the seatback suddenly
folds down.
Never allow passengers to ride
on the folded rear seatback or in
the cargo area ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Delivery and Evaporation LinesREMOVALWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:Be careful not to spill fuel.1. Release the fuel pressure. Fuel > PROCEDURE">2. Open the fuel filler lid and remove the fuel f ...
Removal
LIGHTING SYSTEM > Headlight AssemblyREMOVALCAUTION:• Do not perform work with wet hands, because there is a possibility of electrical shock.• The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.1. Disconnect the g ...