LIGHTING SYSTEM > Glove Box Light
INSPECTION
1. Install the light to test if it illuminates normally.
2. If it fails to illuminate normally, replace the light - pocket with a new part.
NOTE:
Since LED (Light Emitting Diode) is used for the light, replace the light - pocket if the LED burns out.
Adjustment
SECURITY AND LOCKS > Impact SensorADJUSTMENT1. CHECK IMPACT SENSOR1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the windows.3. Close all the doors and rear gate. Leave open the front hood.4. Press the LOCK button of the keyless transmitter or access ...
Dtc c0044 tcm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0044 TCM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from TCM.Trouble symptom:• ABS does not operate.• VDC does not operate.• EyeSight does not operate.STEPC ...
Replacing bulbs
WARNING
Bulbs may become very hot while
illuminated. Before replacing bulbs,
turn off the lights and wait until the
bulbs cool down. Otherwise, there is
a risk of sustaining a burn injury.
CAUTION
Replace any bulb only with a new
bulb of the specified wattage.
Using a bulb of differe ...