LIGHTING SYSTEM > Day Time Running Resistor
INSPECTION
1. Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Specification | Connection diagram |
1 — 2 | Always | 1.13±0.05 ? |
2. Replace the resistor assembly - daytime running light if the inspection result is not within the standard.
Basic operation
Control switch
Up (select)
ENTER (push)
Down (select)
By operating "
" or "
" of the control
switch, the screens and selection items
can be switched. When the button is
pushed, the item can be selected and set. ...
Inspection
WHEEL AND TIRE SYSTEM > Tire and WheelINSPECTION1. TIRECAUTION:When replacing a tire, make sure to use tires of the same size, construction and load range as originally installed.1. Tire size and tire inflation pressure check General Description > SPECIFICATION">2. Cracks, damage and ...
Disassembly
DIFFERENTIALS > Rear Differential (T-type)DISASSEMBLYTo detect the real cause of trouble, inspect the following items before disassembling.• Tooth contact and backlash between hypoid driven gear and drive pinion• Hypoid driven gear runout on its back surface• Total preload of dr ...