LIGHTING SYSTEM > Combination Switch (Light)
INSPECTION
Measure the resistance between connector terminals. If it is not within the standard value, replace the switch assembly - combination turn dimmer.
Preparation tool:
Circuit tester
1. LIGHTING SWITCH
Terminal No. | Inspection conditions | Standard |
18 — 12 19 — 12 20 — 12 | Switch OFF | 1 M? or more |
19 — 12 | Switch AUTO | Less than 1 ? |
18 — 12 | Switch 1 (TAIL/PARKING) | Less than 1 ? |
18 — 12 20 — 12 | Switch 2 (HEAD) | Less than 1 ? |
2. DIMMER & PASSING SWITCH
Terminal No. | Inspection conditions | Standard |
11 — 12 17 — 12 | Switch PASS | Less than 1 ? |
11 — 12 | Switch UP | Less than 1 ? |
3. TURN SIGNAL SWITCH
Terminal No. | Inspection conditions | Standard |
13 — 12 | Switch TURN (RH) | Less than 1 ? |
15 — 12 | Switch TURN (LH) | Less than 1 ? |
4. FRONT FOG LIGHT SWITCH
Terminal No. | Inspection conditions | Standard |
4 — 3 | Switch OFF | 1 M? or more |
Switch ON | Less than 1 ? |
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSTALLATION1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a new oil seal.• Apply CVTF to the oil seal lip and press-fitting surface.ST 499755602PRESS ...
Removal
EXTERIOR/INTERIOR TRIM > Glove BoxREMOVALNOTE:Refer to “Security and Locks” section for key cylinder replacement. Key Lock Cylinders > REPLACEMENT">1. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket ...
Removal
WIPER AND WASHER SYSTEMS > Rear Wiper MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper.(1) Remove the cover - rear wiper arm.(2) Remove the nut, and remove th ...