INSTRUMENTATION/DRIVER INFO > Steering Switch
INSPECTION
1. Measure the resistance between switch terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | |
3 — 2 | (UP) i/SET (DOWN) | All OFF | Approx. 1 M? or more |
(UP) | ON | Less than 1 ? | |
i/SET | ON | Approx. 1,000 ? | |
(DOWN) | ON | Approx. 3,670 ? |
2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
Terminal No. | Inspection conditions | Specification |
4 (+) — 1 (−) | Apply battery voltage. | Light ON |
3. Replace the MID switch if the inspection result is not within the standard value.
SRS airbag system servicing
WARNING
When discarding an airbag module
or scrapping the entire vehicle
damaged by a collision, consult
your SUBARU dealer.
The SRS airbag has no userserviceable
parts. Do not use
electrical test equipment on any
circuit related to the SRS airbag
system. For required servicing o ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Drive GearINSTALLATION1. Install the reduction drive gear to secondary pulley.2. Select the reduction drive gear shim. Reduction Drive Gear > ADJUSTMENT">3. Install the dish plates, spring retainers, and selected reduction drive ge ...
File information
Compatible compressed files (Audio)
Corresponding sampling frequency (Audio)
Corresponding bit rates (Audio)
(Variable Bit Rate (VBR) compatible)
MP3 (MPEG Audio Layer 3), WMA
(Windows Media Audio) and AAC (Advanced
Audio Coding) are audio compression
standards.
This syste ...