INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD)
INSPECTION
1. MULTI-FUNCTION DISPLAY SWITCH
1. Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | |
2 — 3 | (UP) ENTER (DOWN) | All OFF | 1 M? or more |
(UP) | ON | Less than 1 ? | |
ENTER | ON | Approx. 1,000 ? | |
(DOWN) | ON | Approx. 3,670 ? |
2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
Terminal No. | Inspection conditions | Specification |
4 (+) — 1 (−) | Apply battery voltage. | Light ON |
3. If the inspection result is not within the standard, replace the switch - multi-function display.
Wiring diagram
LIGHTING SYSTEM > Stop Light SystemWIRING DIAGRAMRefer to “Stop Light System” in the wiring diagram.• Model without EyeSight: Stop Light System > WIRING DIAGRAM">• Model with EyeSight: Stop Light System > WIRING DIAGRAM"> ...
Caution
BRAKE > General DescriptionCAUTION• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly ...
Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. In ...