Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)

INSPECTION

1. Check if there is anything that affects sensing, around the sunload sensor.

(1) Is the sunload sensor free from any object that disturbs sensing?

(2) Is the windshield glass free from any object such as sticker or film that disturbs sensing?

Yes > Go to step 2).

No > Remove everything that affects sensing.

2. Using the Subaru Select Monitor, check «Quantity of Sunload».

NOTE:

For detailed operation procedures, refer to “Application help”.

(1) Cover the sunload sensor with cloth.

(2) Does the «Quantity of Sunload» indicate 0 W/m2 when the direct sunlight is shielded?

Yes > Go to step 3).

No > Replace the sunload sensor.

3. From step 2), expose the sunload sensor to light.

(1) Place intense light such as incandescent light at 300 mm (11.81 in) or less from the sunload sensor.

(2) Does «Quantity of Sunload» indicate 2,000 W/m2 or less?

CAUTION:

The value changes depending on the angle of light.

Yes > The sunload sensor is normal.

No > Replace the sunload sensor.

Sunload sensor (auto a/c model)
...

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)REMOVALCAUTION:Be careful not to damage the sensors and interior trims when removing.1. Disconnect the ground cable from ba ...

Other materials:

Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...

Dtc p060a internal control module monitoring processor performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P060A INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCE ...

Cup holders
CAUTION Do not pick up a cup from the cup holder or put a cup in the holder while you are driving, as this may distract you and lead to an accident. Take care to avoid spills. Beverages, if hot, might scald you and/or your passengers. Spilled beverages may also damage upholstery ...

© 2016-2024 Copyright www.sucross.com