HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
2. CHECK RELAY
1. Check the resistance between relay terminals.
• A/C relay
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 2
Apply battery voltage between terminals 4 and 3.
Less than 1 ?
• Blower motor relay
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 4 | Always | 1 M? or more |
1 — 4
Apply battery voltage between terminals 2 and 3.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard.
Manual transmission
The manual transmission is a fully synchromeshed,
5-forward-speed and 1-reverse-
speed transmission.
The shift pattern is shown on the shift
lever knob. When shifting from 5th gear to
reverse gear, first return the shift lever to
the neutral position then shift into reverse
gear.
To ...
Ventilator control
Center and side ventilators
Center ventilators
Open
Close
Side ventilators
Open
Close
To adjust the flow direction, move the tab.
To open or close the ventilator, turn the
thumb-wheel up or down. ...
Read diagnostic trouble code (dtc) Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select Sys ...