Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door Actuator
INSPECTION
1. CHECK LINK
1. Visually check the operation range of the link, and remove the foreign material if any.
2. Operate the air flow control dial or switch to check that the link operates normally.
3. If it does not operate normally as the result of inspection, check the motor - actuator mode.
2. CHECK ACTUATOR
1. Check the resistance between actuator terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connector Sketch |
3 — 1 | Always | 80 — 100 ? |
3 — 2
3 — 5
3 — 6
2. Replace the motor - actuator mode if it is found defective as a result of inspection.
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in &ldq ...
Other materials:
Dtc p0747 pressure control solenoid "a" stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0747 PRESSURE CONTROL SOLENOID "A" STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor du ...
Dtc p015a a/f / o2 sensor delayed response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P015A A/F / O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 1NOTE:For the diagnostic procedure, refer to DTC P014C. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P014C A/F / O2 SENS ...
Installation
PARKING BRAKE > Parking Brake Assembly (Rear Disc Brake)INSTALLATIONCAUTION:Be sure the lining surface is free from brake fluid and grease.1. Apply brake grease to the following locations.Preparation items:Brake grease: Dow Corning Molykote 44MA or equivalent• Six contact surfaces of the pa ...
