Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor
INSPECTION
1. MAGNET CLUTCH CLEARANCE INSPECTION
1. Check the clearance of entire circumference around the drive plate and pulley.
Specification:
0.3 — 0.6 mm (0.0118 — 0.0236 in)
2. Replace the compressor assembly if the inspection result is not within the standard.
2. MAGNET CLUTCH OPERATION INSPECTION
1. Check the magnet clutch operation when battery voltage is applied to the compressor terminal.
Terminal No. | Inspection conditions | Specification | Connection diagram |
1 (+) — Chassis ground (−) | Battery connection between compressor terminal and chassis ground | Engaged |
2. If it does not operate normally, replace the compressor assembly.
Compressor
...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorREMOVAL1. CROSSTREK MODEL1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">2. Turn the A/C switch to OFF, and ...
Other materials:
Dtc c1341 rl hold valve
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1341 RL HOLD VALVENOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1362 NORMAL C ...
Removal
WIPER AND WASHER SYSTEMS > Front Wiper ArmREMOVAL1. MODELS WITHOUT EyeSight1. Remove the cover - windshield wiper arm.2. Remove the nuts, and remove the arm assembly - windshield wiper.2. MODELS WITH EyeSight1. Remove the cover - windshield wiper arm.2. Remove the arm assembly - windshield wiper. ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyINSTALLATION1. Clean the mating surface of drive pinion retainer and converter case.2. Adjust the backlash and tooth contact between drive pinion shaft assembly and the front differential side gear. Drive Pinion Shaft Assembl ...
