HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door Actuator
INSPECTION
1. CHECK LINK
1. Visually check the operation range of the link, and remove the foreign material if any.
2. Operate the temperature control dial to check that the link operates normally.
3. If it does not operate normally as the result of inspection, check the motor - actuator mix.
2. CHECK ACTUATOR
1. Check the resistance between actuator terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connector Sketch |
3 — 1 | Always | 80 — 100 ? |
3 — 2
3 — 5
3 — 6
2. Replace the motor - actuator mix if it is found defective as a result of inspection.
Removal
SEATS > Rear SeatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is located in the lowe ...
Caution
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionCAUTION1. Airbag system wiring harness is routed near the ECM, main relay and fuel pump relay.CAUTION:• Do not use electrical test equipment on the airbag system circuits.• Be careful not to damage the airbag system wiring harness when s ...
Inspection
SECURITY AND LOCKS > Keyless TransmitterINSPECTION1. KEYLESS TRANSMITTER BATTERY1. Check the keyless transmitter battery voltage.PREPARATION TOOL:Circuit testerNOTE:Complete the measurement within 5 seconds because the battery discharges during measurement.Battery terminalInspection ConditionsSta ...