GLASS/WINDOWS/MIRRORS > Remote Control Mirror Switch
INSPECTION
1. Disconnect the connector of the switch - door mirror.
2. Check the resistance between switch - door mirror terminals.
Preparation tool:
Circuit tester
• Changeover switch RH
Terminal No. | Inspection conditions | Standard |
— | OFF | 1 M? or more |
1 — 12 9 — 7 | UP | Less than 1 ? |
1 — 9 12 — 7 | DOWN | Less than 1 ? |
1 — 11 12 — 7 | LEFT | Less than 1 ? |
1 — 12 11 — 7 | RIGHT | Less than 1 ? |
• Changeover switch LH
Terminal No. | Inspection conditions | Standard |
— | OFF | 1 M? or more |
1 — 14 8 — 7 | UP | Less than 1 ? |
1 — 8 14 — 7 | DOWN | Less than 1 ? |
1 — 10 14 — 7 | LEFT | Less than 1 ? |
1 — 14 10 — 7 | RIGHT | Less than 1 ? |
3. If the inspection result is not within the standard, replace the switch - door mirror.
Electrical component location Location
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Headlight ASSY– Headlight beam leveler actuator(4)Headlight relay (Hi)(7)Combination meter(2)Rear vehicle height sensor(5)Body integrated unit(8)Fuse 10 A (auto headlight beam leveler CM)(3)Headlight rel ...
System block diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAM• Blind Spot Detection/Rear Cross Traffic Alert system consists of the following.• There is a control ECM in the radar sensor main body, which performs the vehicle identification ...
Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT">• Make sure that engine does not start with clutch pedal no ...