Subaru Crosstrek Service Manual: Inspection
GLASS/WINDOWS/MIRRORS > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and check visually.
2. If the fuse is blown out, replace the fuse.
2. CHECK RELAY
1. Check the resistance between relay terminals.
Terminal No. | Inspection conditions | Specification | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 2
Apply battery voltage between 4 — 3 terminals.
Less than 1 ?
Terminal No. | Inspection conditions | Specification | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 4
Always
Less than 1 ?
1 — 2
Apply battery voltage between 3 — 5 terminals.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard value.
Relay and fuse
...
Location
GLASS/WINDOWS/MIRRORS > Relay and FuseLOCATIONMain fuse boxRear defogger relay(A)Fuse 25 A (rear defogger)(B)Relay & fuse boxFuse 7.5 A (remote control mirror)(C)Fuse 15 A (wiper deicer)(D)Fuse ...
Other materials:
Dtc b1638 curtain airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1638 CURTAIN AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (LH) ...
Inspection
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSPECTION1. WASHER PUMPApply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates.2. WASHER FLUID LEVEL SENSOR1. Check the connection status of washer fluid level sensor connector.2. D ...
Adjustment
FRONT SUSPENSION > Wheel AlignmentADJUSTMENTCAUTION:When the wheel alignment has been adjusted, perform the adjustment of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">1. FRONT CAMBER1. Adjust the camber angle to the following value.Tire sizeCamb ...
