GLASS/WINDOWS/MIRRORS > Front Regulator and Motor Assembly
INSPECTION
1. Disconnect the connector of the motor - front.
2. Check the motor operation when battery voltage is applied between terminals of the motor - front connector.
• LH side
Terminal No. | Inspection conditions | Standard |
4 (+) — 1 (−) | Apply battery voltage between terminals. | Increase |
1 (+) — 4 (−) | Apply battery voltage between terminals. | Decrease |
• RH side
Terminal No. | Inspection conditions | Standard |
3 (+) — 6 (−) | Apply battery voltage between terminals. | Increase |
6 (+) — 3 (−) | Apply battery voltage between terminals. | Decrease |
3. If it does not operate properly as a result of inspection, replace the regulator and motor assembly - front.
Component
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > General DescriptionCOMPONENT1. HEATER AND COOLING UNIT• Manual A/C model(1)Pipe - inlet(11)Shutter - defroster(21)Packing - evaporator core(2)Pipe - outlet(12)Shutter - vent(22)Pipe - evaporator core(3)Clamp - pipe(13)Shutter - air mix RH(23)Case - ...
Wiring diagram
ENTERTAINMENT > Audio SystemWIRING DIAGRAM1. AUDIORefer to “Audio System” in the wiring diagram.• 6.2 inch display: Audio System > WIRING DIAGRAM">• 7 inch display (model without telematics): Audio System > WIRING DIAGRAM">• 7 inch display (mo ...
Dtc p0455 evap system (cpc) leak detected (large leak)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0455 EVAP SYSTEM (CPC) LEAK DETECTED (LARGE LEAK)DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Fuel odor• There is a hole of more than 1.0 ...