Subaru Crosstrek Service Manual: Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor
INSPECTION
1. CRANKSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)
1. Prepare an oscilloscope.
2. Remove the glove box. Glove Box > REMOVAL">
3. Connect the probe to ECM connector.
Terminal No. | Probe |
16 | + |
1 | − |
4. Start the engine and let it idle.
5. Check the waveforms and voltage.
NOTE:
For waveform and voltage, refer to “Engine Control Module (ECM) I/O Signal”. Engine Control Module (ECM) I/O Signal > ELECTRICAL SPECIFICATION">
6. After inspection, install the related parts in the reverse order of removal.
2. OTHER INSPECTIONS
Check that the crankshaft position sensor has no deformation, cracks or other damages.
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake ...
Other materials:
Inspection
LIGHTING SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection condit ...
Glossary of tire terminology
Accessory weight
The combined weight (in excess of
those standard items which may be
replaced) of automatic transmission,
power steering, power brakes,
power windows, power seats, radio,
and heater, to the extent that these
items are available as factory-installed
equipment (whether ins ...
Dtc b2900 ahl control
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2900 AHL CONTROLDTC DETECTING CONDITION:Detected when internal malfunction occurs in the auto headlight beam leveler CM.TROUBLE SYMPTOM:The auto headlight beam leveler does not operate.C ...
