FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position Sensor
INSPECTION
1. CAMSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)
1. Prepare an oscilloscope.
2. Remove the glove box. Glove Box > REMOVAL">
3. Connect the probe to ECM connector.
• Intake camshaft position sensor
• Exhaust camshaft position sensor
Camshaft position sensor | Terminal No. | Probe | |
Intake | RH | 26 | + |
LH | 15 | + | |
Exhaust | RH | 14 | + |
LH | 25 | + | |
RH and LH | 3 | − |
4. Start the engine and let it idle.
5. Check the waveforms and voltage.
NOTE:
For waveform and voltage, refer to “Engine Control Module (ECM) I/O Signal”. Engine Control Module (ECM) I/O Signal > ELECTRICAL SPECIFICATION">
6. After inspection, install the related parts in the reverse order of removal.
2. OTHER INSPECTIONS
Check that the camshaft position sensor has no deformation, cracks or other damages.
Dtc p170a l-range switch
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P170A L-RANGE SWITCHDTC DETECTING CONDITION:Immediately at fault recognitionNOTE:Refer to “DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE” for diagnostic proced ...
Dtc u0427 invalid data received from vehicle security control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0427 INVALID DATA RECEIVED FROM VEHICLE SECURITY CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operat ...
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...