FRONT SUSPENSION > Front Strut
INSPECTION
Check the removed part for wear, damage and cracks, and then repair or replace it if defective.
1. STRUT
1. Check for oil leaks.
2. Move the piston rod up and down to check that it operates smoothly without any hitch.
3. Check the piston rod runout.
Preparation tool:
Dial gauge
(1) Fix the outer shell.
(2) Extend the piston rod until it stops retracting, and set the dial gauge at the L position from the end of the piston rod.
Measuring point:
L = 10 mm (0.39 in)
(3) While applying a force of W1 [20 N (2 kgf, 4 lbf)] to the arrowed section, read the dial gauge indication P1.
(4) While applying a force of W2 [20 N (2 kgf, 4 lbf)] from the opposite side of W1, read the dial gauge indication P2.
Play limit (P1 + P2): 0.8 mm (0.031 in)
4. Replace the strut if faulty is found in the inspection or limit value is exceeded.
2. STRUT MOUNT - FRONT
Check the rubber part for deformation, cracks or deterioration, and then replace it with a new part if defective.
3. DUST COVER - INNER
If cracks or damage are found, replace it with a new part.
4. COIL SPRING - FRONT
If a permanent strain is found, replace it with a new part.
5. HELPER - FRONT STRUT
If major cracks or damage are found, replace it with a new part.
Dtc p2746 intermediate shaft speed sensor "b" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2746 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• ...
Installation
SECURITY AND LOCKS > Keyless Access CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FO ...
Removal
CLUTCH SYSTEM > FlywheelREMOVAL1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL">2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOVAL">3. Attach the ST.ST 498497100CRANKSHAFT STOPPER(A)Flywheel4. Remove the flywheel and ...