Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

EyeSight > Switches and Harness

INSPECTION

1. PRE-COLLISION BRAKE OFF SWITCH AND LANE DEPARTURE WARNING OFF SWITCH

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Pre-collision brake OFF switch

Terminal No.

Inspection conditions

Standard

10 — 8

OFF

Approx. 1 k?

ON

Less than 1 ?

Lane departure warning OFF switch

Terminal No.

Inspection conditions

Standard

9 — 8

OFF

Approx. 1 k?

ON

Less than 1 ?

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.

Inspection conditions

Specification

1 (+) — 2 (−)

Apply battery voltage.

Light ON

3. Replace the stereo camera cover assembly if faulty is found in the inspection.

2. EyeSight STEERING SWITCH

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.

Inspection conditions

Standard

3 — 9

CRUISE (MAIN)

SET/−

RES/+

All OFF

Approx. 4,020 ?

CRUISE (MAIN)

ON

Less than 1 ?

SET/−

ON

Approx. 250 ?

RES/+

ON

Approx. 1,470 ?

4 — 9

DISTANCE

OFF

1 M? or more

ON

Less than 1 ?

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.

Inspection conditions

Specification

10 (+) — 11 (−)

Apply battery voltage.

Light ON

3. Replace the EyeSight steering switch if it is found defective.

Switches and harness
...

Note
EyeSight > Switches and HarnessNOTE1. PRE-COLLISION BRAKE OFF SWITCH & LANE DEPARTURE WARNING OFF SWITCHThe pre-collision brake OFF & lane departure warning OFF switch is integrated in the ...

Other materials:

Parking on a grade
Always block the wheels under both vehicle and trailer when parking. Apply the parking brake firmly. You should not park on a hill or slope. If parking on a hill or slope cannot be avoided, you should take the following steps: 1. Apply the brakes and hold the pedal down. 2. Have someone pl ...

Dtc p0756 shift solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0756 SHIFT SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor ...

Front differential gear oil (CVT models) and rear differential gear oil
It is not necessary to check the gear oil level. Check that there are no cracks, damage or leakage. However, the oil inspection should be performed according to the maintenance schedule in the "Warranty and Maintenance Booklet". Consult your SUBARU dealer for details. Recommended grade and ...

© 2016-2024 Copyright www.sucross.com