Subaru Crosstrek Service Manual: Inspection

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

NOTE:

If the fuse is blown again, check the system wiring harness.

Relay and fuse

Location

Other materials:

Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. In ...

Dtc c0033 fl hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0033 FL HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...

After driving
Always check your brakes for effectiveness immediately after driving in sand, mud or water. Do this by driving slowly and stepping on the brake pedal. Repeat that process several times to dry out the brake discs and brake pads. After driving through tall grass, mud, rocks, sand, riv ...