Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

ENTERTAINMENT > Rearview Camera System

INSPECTION

1. Park the vehicle at the level place where there are enough area at the rear of the vehicle.

2. Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.

NOTE:

Standard tape width is about 30 — 50 mm (1.18 — 1.97 in) and brilliant color shall be used.

(A)

Vehicle body center line

(B)

Rear edge of bumper

(C)

Target point

3. Confirm the following before checking the corresponding items.

(1) Rearview camera image is not displayed. (Audio and navigation screens are displayed normally.)

(1) Check the condition of back sensor connection.

Audio system: Audio System > OPERATION">

Navigation system: Navigation System > OPERATION">

(2) Check the condition of rearview camera connection.

Audio system: Audio System > OPERATION">

Navigation system: Navigation System > OPERATION">

(2) Marker position is not aligned or displayed.

The rearview camera or its installation location on the vehicle may be deformed. Check the rearview camera and its installation location on the vehicle, and repair or replace if necessary.

Rearview camera system
...

Wiring diagram
ENTERTAINMENT > Rearview Camera SystemWIRING DIAGRAMRefer to “Rearview Camera System” in the wiring diagram.– 6.2 inch display: Rearview Camera System > WIRING DIAGRAM">â ...

Other materials:

Dtc p013e o2 sensor delayed response - rich to lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013E O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 2NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESP ...

Dtc b1828 short in side airbag lh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1828 SHORT IN SIDE AIRBAG LH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) is shorted to power supply.• Side airbag module (LH) is faulty.• ...

Selecting audible signal operation (models without "keyless access with push-button start system")
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Perform the following steps to deactivate the audible signal. You can also use the same steps to restore the function. 1. Sit in the drive ...

© 2016-2024 Copyright www.sucross.com