Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Emission control (aux. Emission control devices)(h4do) / Rear catalytic converter / Inspection

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Rear Catalytic Converter

INSPECTION

1. Check the connections and welded parts for exhaust leaks.

2. Make sure there are no holes or rusting.

Removal

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Rear Catalytic ConverterREMOVALThe rear catalytic converter is integrated into the center exhaust pipe; therefore, refer to “Center Ex ...

Other materials:

System operation
Operating conditions The BSD/RCTA will operate when all of the following conditions are met. The ignition switch is in the "ON" position. The BSD/RCTA warning indicator and BSD/RCTA OFF indicator are turned off. The vehicle is driven at speeds above 6 mph (10 km/h) (except when rever ...

Fuel pump circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureFUEL PUMP CIRCUITCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspection Mode Inspection Mode > PROCEDURE">.Wiring diagram:Engine electr ...

Removal
LIGHTING SYSTEM > Front Turn Signal Light BulbREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Turn the steering wheel in the opposite direction from the parts to be removed. Then remove the clips and turn over the mud guard - front.3. Remove the bulb socket and front turn si ...