EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid Valve
INSPECTION
1. PURGE CONTROL SOLENOID VALVE
1. Check that the purge control solenoid valve has no deformation, cracks or other damages.
2. Measure the resistance between the purge control solenoid valve terminals.
Terminal No. | Standard |
1 and 2 | 24.5±1.5 ? (20°C (68°F)) |
3. Check that air does not come out from (B) when air is blown into (A).
4. Connect the battery positive terminal to the terminal No. 1 and the battery negative terminal to the terminal No. 2. Check that air is discharged from (B), when supplying air to (A).
2. OTHER INSPECTIONS
Check the vacuum hose for cracks, damage or looseness.
Removal
EXTERIOR/INTERIOR TRIM > Floor MatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
Coat hook
A coat hook is attached to the rear
passenger's hand grip.
WARNING
Obey the following instructions.
Do not hang coat hangers or
other hard or pointed objects on
the coat hooks. Hang clothing
directly on the coat hooks without
using hangers.
Before hanging clothing on the
coat ...
Installation
AIRBAG SYSTEM > Passenger’s Airbag ModuleINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do not allow harness and ...