EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Fuel Level Sensor
INSPECTION
For inspection procedures, refer to the “FU (H4DO)” section. Fuel Level Sensor > INSPECTION">
RemovalDisassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyDISASSEMBLY1. Put vinyl tape around main shaft spline to protect the oil seal from damage. Then pull out the oil seal and needle bearing by hand.2. Remove the lock nut and lock washer.NOTE:Flatten the lock nut tab before removing the ...
Dtc p0606 control module processor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0606 CONTROL MODULE PROCESSORDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, p ...
Airbag connector Procedure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Airbag ConnectorPROCEDURE1. OCCUPANT DETECTION SYSTEM (BETWEEN AIRBAG REAR HARNESS AND SEAT HARNESS)1. How to disconnect:Press the lock arm (A) and disconnect the connector.CAUTION:When pulling the slide lock or disconnecting connector, be sure to hold th ...