Subaru Crosstrek Service Manual: Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Canister
INSPECTION
1. Check that the canister has no deformation, cracks or other damages.
2. Check that the tube has no cracks, damage or loose part.
Canister
...
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > CanisterREMOVAL1. Lift up the vehicle.2. Remove the rear exhaust pipe. Rear Exhaust Pipe > REMOVAL">3. Remove the propeller shaf ...
Other materials:
General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionSelect leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back-up light does not illuminate.Adjust the select cable and inhibitor switch, or inspect the circuit.A ...
Inspection
LIGHTING SYSTEM > Rear Height SensorINSPECTION1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using a circuit tester, check that the initial voltage of each dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive PlateINSTALLATION1. Temporarily install the drive plate and reinforcement drive plate.NOTE:Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.2. Set the ST.ST 498497300CRA ...
