Subaru Crosstrek Service Manual: Inspection
DRIVE SHAFT SYSTEM > Rear Hub Unit Bearing
INSPECTION
1. Moving the rear tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.
CAUTION:
If there is unsmooth sliding operation or abnormal noise in the bearing, replace the rear hub unit bearing.
2. Inspect the hub unit bearing for axial looseness.
(1) Remove the tire and disc rotor.
(2) Using a dial gauge, check the axial looseness. Replace the hub unit bearing if looseness exceeds the limit.
Service limit:
Maximum: 0.05 mm (0.0020 in)
Disassembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the rear hub unit bearing (a).CAUTION:• Be careful not to hammer the hub ...
Installation
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSTALLATION1. Place the rear brake back plate between the rear axle housing and the rear hub unit bearing, and tighten the bolt.CAUTION:• Be careful ...
Other materials:
Initialize
Items that have been set to your preference
can be initialized. To select an
initialization menu, operate the "
" or " "
switch as follows.
Preparation for initialization
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to show
the selection screen.
3. ...
By contacts list
On the phone (menu) screen, select the
"Contacts" key to open the phone number
list screen.
You can make a call by selecting an item
in the list (up to five phone numbers are
listed).
If there is no contact data, a message is
displayed to indicate that there is no contact data.
Conta ...
Inspection
LUBRICATION(H4DO) > Engine OilINSPECTIONCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. Park the vehicle on a level surface.2. Turn the ignition switch to OFF.3. Remove the oil level gauge and wipe away t ...