Subaru Crosstrek Service Manual: Inspection
DIFFERENTIALS > Rear Differential Front Member
INSPECTION
1. Check the rear differential front member for damage, bend and corrosion.
If damage, bend or corrosion is excessive, replace the rear differential front member.
2. Check the bushings of rear differential member for cracking, hardening and damage. If cracking, hardening or damage is excessive, replace rear differential front member.
Removal
DIFFERENTIALS > Rear Differential Front MemberREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Support the rear differential using transmission jack, and then remove the ...
Other materials:
Installation
EXTERIOR BODY PANELS > Front DoorINSTALLATION1. FRONT DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - front door on it.2. Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.3. Adjust the height by the jack, and temporarily install the p ...
Preparation tool
DRIVE SHAFT SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONPART NO.DESCRIPTIONREMARKS20099PA010INSTALLER & REMOVER• Used for replacing the rear bushing of rear axle housing.• Used together with BUSHING REMOVER (20099FG000).20099FG000BUSHING REMOVER• U ...
Electrical specification
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. KEYLESS ACCESS CMTerminal No.Terminal symbolContent(B572) No. 2+B+B(B572) No. 3INDSStart switch indicator (green) output(B572) No. 5N-SWNeutral switch input(B572) No. 7STSWSTSW output( ...
