COOLING(H4DO) > Thermostat
INSPECTION
1. Check that the thermostat does not have deformation, cracks or damage.
2. Check that the thermostat valve closes completely at an ambient temperature.
3. Immerse the thermostat and a thermometer in water. Raise water temperature gradually, and check the temperature and valve lift when the valve begins to open and when the valve is fully opened. Replace the thermostat if faulty.
NOTE:
• During the test, agitate the water for even temperature distribution.
• Leave the thermostat in the boiling water for five minutes or more before measuring the valve lift.
• Hold the thermostat with a wire or the like to avoid contacting with container bottom.
Starting temperature to open:
Engine side
90 — 94°C (194 — 201°F)
CVTF cooler (with warmer feature) side
48 — 52°C (118 — 126°F)
Full open temperature:
Engine side
100°C (212°F)
CVTF cooler (with warmer feature) side
63°C (145°F)
Total valve lift:
Engine side
8.0 mm (0.315 in) or more
CVTF cooler (with warmer feature) side
6.0 mm (0.236 in) or more
(A) | Thermometer | (B) | Thermostat |
EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner's Manual supplement
for the EyeSight system.
BSD/RCTA (if equipped)
After entering the "BSD/RCTA" menu,
select the "Warning Volume" menu. You
can set the volume of the warning buzzer
for RCTA (Rear Cross Traffic Alert). You
can se ...
Select play mode
The play mode settings display will appear
when play mode key is touched. Select
the preferred play mode from the following
items.
Icon
Function
Touch to start 1 track repeat.
Touch to start repeat all.
Touch to start folder repeat.
T ...
Dtc p0365 camshaft position sensor "b" circuit bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0365 CAMSHAFT POSITION SENSOR "B" CIRCUIT BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stall• Failure of engine to startCAUTION:After servicing ...