Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

CONTROL SYSTEMS > Select Cable

INSPECTION

Check the removed cable and replace or adjust if damaged, rusty or malfunctioning.

1. Check the cable for smooth operation.

2. Check the inner cable for damage and rust.

3. Check the outer cable for damage, bends and cracks.

4. Check the boot for damage, cracks and deterioration.

5. Move the select lever from “P” to “D” range. Check the existence of feel to contact the detents in each range. If the detents cannot be felt or the position pointer is improperly aligned, adjust the cable.

6. Check if the starter motor rotates when the select lever is set to “P” range.

7. Check the back-up light illumination when the select lever is in “R” range.

8. Check the parking lock operation when the select lever is in “P” range.

Removal
CONTROL SYSTEMS > Select CableREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect th ...

Installation
CONTROL SYSTEMS > Select CableINSTALLATION1. Position the select cable as shown in the figure, and install it to the plate assembly.CAUTION:• If the cable is installed in the wrong direction, ...

Other materials:

Operation
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence ControlOPERATION1. While the ABS sequence control is being performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve operation.2. ABS sequence control can be started ...

Dtc u0122 lost communication with vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data from VDC CM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Pro ...

Head restraint height adjustment
Head restraint Release button To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: While pressing the release button, pull out the head restraint. To install: Install the head ...

© 2016-2026 Copyright www.sucross.com