Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Mounting System

INSPECTION

• Check the crossmember for bends or damage.

• Check that the cushion rubber is not stiff, cracked or otherwise damaged.

• Check the pitching stopper for bends or damage.

Transmission mounting system
...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, dis ...

Other materials:

Dtc p0328 knock/combustion vibration sensor 1 circuit high bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0328 KNOCK/COMBUSTION VIBRATION SENSOR 1 CIRCUIT HIGH BANK 1 OR SINGLE SENSORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Poor driving performance• Knocking occursCAUT ...

Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Learning ControlPROCEDURE1. PREPARATION FOR LEARNING1. Warm up or cool down until the ATF temperature displayed on the Subaru Select Monitor is 40 — 65°C (104 — 149°F).2. After stopping the vehicle, shift the select leve ...

Installation
EXTERIOR/INTERIOR TRIM > Rear BumperINSTALLATIONInstall each part in the reverse order of removal.CAUTION:Before installing the bumper face, match the claws on the bracket - rear bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, ...

© 2016-2026 Copyright www.sucross.com