CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure Sensor
INSPECTION
1. Start and warm up the engine.
2. Depress the brake pedal, and shift the select lever to “D” range.
3. Shift the select lever to “P” or “N” range.
4. Depress the brake pedal and hold it.
5. Check «secondary pressure sensor voltage» by using Subaru Select Monitor while the engine is idling. Subaru Select Monitor > OPERATION">
Standard
Approx. 0.8 V
6. Check «secondary pressure sensor voltage» by using Subaru Select Monitor while the engine is stopped and the ignition switch is turned on. Subaru Select Monitor > OPERATION">
Specification:
Approx. 0.5 V
Communication for initializing impossible
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Subaru Select MonitorCOMMUNICATION FOR INITIALIZING IMPOSSIBLENOTE:Confirm that the LAN system is working properly before the diagnosis.Subaru Select Monitor communication line is open or shorted.Detecting condition:• Defective ha ...
Welcome screen and Good-bye screen
When the driver's door is opened and
closed after unlocking the door, the
welcome screen will appear on the multi
information display for approximately 20
seconds.
When the ignition switch is turned to the
"LOCK"/"OFF" position, the multi information
display gradually turns off (Good-bye
s ...
Dtc u0401 invalid data received from ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLINE OF ...